Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Andover?
Garage door repair in Andover typically costs $150 to $600, depending on what failed and how many parts are involved. A single broken spring usually runs $180 to $340, while a full new door installation typically falls between $700 and $2,200. Those are estimated ranges for the Andover market; the written estimate you get after we look at the door sets the final price.
We work on the brands Andover homes actually have: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. That brand familiarity means fewer return trips and the right parts the first time. Estimates are free, same-day service is available, and you can reach us at (877) 711-1381. Our technicians have up to 14 years of experience, and the local pro we connect you with is licensed and insured as Minnesota requires.
Key Takeaways
- Typical garage door repair in Andover: $150 to $600.
- One spring replaced: $180 to $340. A matched pair is usually replaced together, so a pair costs about twice that.
- New door installation: $700 to $2,200, driven mostly by door size, material and insulation.
- Free estimates, same-day service, and emergency service when a door won’t close and can’t wait until Monday.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs run in Andover. Every range below is typical and estimated, and the written estimate is what you actually pay.
| Job | Typical Estimated Cost | What It Covers |
|---|---|---|
| Garage door repair (general) | $150 to $600 | Diagnosis plus the fix for most single-point failures |
| Spring repair (one spring) | $180 to $340 | Torsion or extension spring replacement, one spring |
| Cable repair | $130 to $250 | Frayed or snapped lift cable and drum check |
| Opener repair | $120 to $320 | Logic board, travel limits, safety sensors, gear and drive fixes |
| Opener installation | $250 to $550 | New opener, rail, mounting and calibration |
| Panel replacement | $250 to $500 | One damaged section, color-matched where possible |
| Track realignment | $120 to $240 | Bent or knocked-out track brought back to true |
| Roller replacement | $110 to $220 | Full set of rollers, quiet nylon or steel |
| New door installation | $700 to $2,200 | Door, hardware, springs and tracks set up for the opening |
Why a matched spring pair costs more
When one spring breaks, the other has usually been carrying the same load for the same number of cycles, so it’s close behind. We replace springs as a matched pair for that reason, and a pair costs about twice the single-spring range. We’ll show you the condition of both springs before anything is ordered so the decision is yours.
What drives the price up or down
The biggest swing is whether one part failed or several things are tired at once. A snapped cable is usually a straightforward repair. A sagging door with a worn cable, two tired springs and a bent track is a bigger job because the parts have to work together. Door size matters too: a single-car door on a detached Andover garage uses smaller, less expensive springs and panels than a wide two-car door. Insulated doors cost more than uninsulated ones, and custom colors or window inserts move panel replacement toward the top of its range. Opener work depends on the unit: a straightforward sensor or travel-limit fix lands near $120, while a failed logic board or a stripped gear on an older unit pushes toward $320.
What Affects Garage Door Pricing in Andover
- Winter cycle load. Andover winters are hard on garage doors. Sand and road grit that get tracked into the garage work into rollers and hinges, and the freeze-thaw swing from January cold to spring melt stresses springs and cables. Doors here cycle more than most people realize just getting in and out during a long winter, so spring and roller wear shows up earlier.
- Frozen and heaved tracks. Frost heave under a slab can shift a track out of plumb, and ice built up at the threshold can knock a bottom section out of line. That’s a real reason track realignment comes up in this market more than people expect.
- Door size and material. A wide insulated door in Andover costs more to repair and replace than a standard single-car door. Steel, wood-look and full-insulated panels each sit in different parts of the installation range.
- Opener age and brand. We’re factory-familiar with the Chamberlain and LiftMaster ecosystem and also work on Genie and Craftsman units, which covers most of what’s in Andover garages. A common brand means faster diagnosis and correct parts without guesswork.
- Emergency timing. A door stuck open in a snowstorm or a door that won’t close can’t wait until Monday. Emergency service is a real offering here, and the pricing reflects the same ranges plus the reality of the timing.
- Whether it’s one part or several. A single spring is one line on the estimate. A door with a worn cable, a tired spring and a misaligned track is a combined job, and the total moves toward the top of the $150 to $600 repair range.
How to Save on Garage Door Repairs in Andover
The single best way to keep costs at the low end is to catch problems early. A door that’s getting louder, slower or slightly crooked is telling you something is wearing. Getting it looked at then usually means one part instead of three.
- Get the estimate in writing before work starts. Free estimates mean you know the number before anything is touched, so there are no surprises on the bill.
- Fix the worn part, not the whole system. Rollers and cables are inexpensive on their own. If you catch a frayed cable before it snaps, you avoid the track and panel damage a snapped cable can cause.
- Ask about a matched spring pair up front. Replacing one spring and then the other a few months later costs more in two visits than doing both together.
- Don’t skip the annual look-over. A quick check of rollers, hinges and the balance of the door catches the cheap fixes before they turn into expensive ones.
- Compare repair against replacement honestly. A door that’s had repeated failures on multiple parts is sometimes better replaced than patched again. We’ll tell you which side of that line you’re on.
Call (877) 711-1381 for a free estimate and we’ll walk you through the options for your specific door and opener brand.
Repair or Replace? A Straight Answer for Andover Homeowners
Repair is usually the right call when the door structure is sound and the problem is a single failed part: a spring, a cable, a roller set or an opener that needs fixing. Replacement makes more sense when multiple parts are failing at once, the panels are dented or rusted through, or the door is old enough that you’re fixing something new every season. In Andover, where doors take a real beating from winter grit and freeze-thaw, a door that’s limped through several winters with repeated repairs is often telling you it’s done. A new door installation at $700 to $2,200 also comes with the benefit of fresh springs and hardware, which resets the repair clock.
Since garage doors and openers are one system, an opener that’s struggling might be reacting to a door that’s out of balance rather than failing on its own. That’s why we look at both before recommending work. One call covers it: repair, opener, spring or full installation.
What a Typical Garage Door Job in Andover Looks Like
A visit usually starts with a look at the whole door, not just the part that failed. We check the springs, cables, rollers, hinges, tracks and the opener, because a broken spring often shows up alongside a frayed cable or a roller that’s flat-spotted from grit. Once we know what’s actually worn, you get a written estimate with the parts and labor separated out. Then the work gets done, the door gets tested through a full open and close cycle, and the opener gets re-checked for travel limits and safety sensors. If the job is a new installation, the door, springs and tracks are set up for that specific opening so the door balances correctly.
Our technicians have up to 14 years of experience, and spring work is handled as a core service, not an add-on, because springs are the most dangerous part of a garage door.
Safety: Why Springs and Cables Aren’t a DIY Job
Torsion springs and the cables that run with them are under high tension even when the door is down. A spring that lets go while someone is working on it can cause serious injury, and the same is true of a cable that snaps under load. This is why we handle spring and cable work as a trained, safety-critical job and recommend a professional for anything involving those parts. Track and roller work carries its own risk too: a door that comes out of its track unexpectedly is heavy and unpredictable. If your door is stuck, off its track or has a visibly broken spring, keep people and vehicles clear of it and call us rather than trying to force it. That keeps everyone safe and usually keeps the repair at the lower end of the range.
FAQs – Garage Door Cost in Andover
How much does garage door repair cost in Andover?
Garage door repair in Andover typically costs $150 to $600. The range depends on how many parts are involved; a single failed component usually lands toward the low end, while a combined spring, cable and track job moves toward the top. Call (877) 711-1381 for an exact quote; estimates are free.
How much does a new garage door cost in Andover?
New door installation in Andover typically costs $700 to $2,200. Door size, material and insulation drive most of the difference, with insulated and larger two-car doors at the higher end. Call (877) 711-1381 for an exact quote; estimates are free.
Is it cheaper to repair or replace a garage door?
Repair is usually cheaper when the frame and panels are in good shape and only one part has failed. A spring repair at $180 to $340 costs far less than a new door at $700 to $2,200. Replacement starts to make sense when multiple parts are failing at once. Call (877) 711-1381 and we’ll give you a straight answer for your door; estimates are free.
How much does a garage door spring cost in Andover?
One spring typically costs $180 to $340 to replace in Andover. A matched pair is usually replaced together, so a pair costs about twice that range. Call (877) 711-1381 for an exact quote; estimates are free.
Can you come today for a stuck garage door in Andover?
Yes, same-day service is available, and we offer emergency service when a door is stuck open or won’t close. Pricing follows the same ranges as a standard repair, $150 to $600 depending on the job. Call (877) 711-1381 and we’ll get you back up and running.
Get a Free Estimate in Andover
If your door needs a look, we’ll come out, diagnose it and give you a written estimate before anything gets touched. We work on the brands you already own, from LiftMaster and Chamberlain openers to Clopay, Amarr, Wayne Dalton and Raynor doors. Whether it’s a snapped spring, an opener that’s acting up, a panel that’s taken a hit or a full replacement, one call covers it. Maple Grove Garage Door Repair Co connects Andover homeowners with independent local professionals, and the local pro is licensed and insured as Minnesota requires. Call (877) 711-1381 for a free estimate today.
Pricing reflects the Andover market as of 2026. Maple Grove Garage Door Repair Co offers free estimates – call (877) 711-1381.
Written by the team at Maple Grove Garage Door Repair Co.
What Our Customers Say
"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Gilbert Torres"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Carrie Sullivan"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Robert Delaney